5 thoughts on “Arduino with servo lifting 7.5kg / 16.5pounds

  1. Hi, I have a problem with my servomotor. I'm programming it with arduino and I give it a position but when it reaches it it does not stabilize but it keeps moving. I'm using a 1501MG servomotor with a 5 volt supply at 2 amps. Any ideas?

  2. Is it necessary to use PCA board to lift heavy load from servo? or with just arduino uno i would be able to lift load between 5 to 6 kg so that it does not burn MCU..

Leave a Reply

Your email address will not be published. Required fields are marked *