0 Comments


Take one Body Spray Bottle and I.V. Infusion Sets Cut the cap of bottle, take width of approx. 1 cm Cut the side portion of cap, approx. 1.5 cm (from that water exhaust) Fix the motor on cap of bottle Use the metal of bottle to make propeller for Pump Take the winds width slightly smaller than cap width Fix the propeller on motor shaft in cap Close the open cap with plastic plate, make the hole in plate (where water go inside) Connect I-V set to side open portion of cap Electric water pump is ready to use (Apply 12 V DC)

Leave a Reply

Your email address will not be published. Required fields are marked *