Trailer Hitch Installation – 2011 Honda CR-V – Draw-Tite – etrailer.com
2 Comments


Today on our 2011 Honda CR-V, we’re going
to install the draw tight hitch, part number 75547. This is what the hitch will look like once
it’s installed. Here are few measurements that will assist
you with selecting accessories for your new hitch. From the center of the hitch pin hole to the
outermost edge of the bumper is three inches. From the top of the receiver tube to the ground
is fifteen inches. This will assist you with selecting accessories
such as a draw bar, a bike rack, or a cargo carrier. Now let’s go ahead with the installation. Before we can install our hitch, we’re going
to need to lower the vehicle exhaust. To do this, we’re going to remove the two
rubber isolators holding the muffler. To remove the rubber isolators, we’ll spray
each one with a little spray lubricant; this will help with the removal and re-installation. Then you can take a pry bar or pliers and remove the inside isolator and then the outside isolator.

2 thoughts on “Trailer Hitch Installation – 2011 Honda CR-V – Draw-Tite – etrailer.com

Leave a Reply

Your email address will not be published. Required fields are marked *